Chapter 1-2: Bus Licence, Inspetion and Road Check

Free Ontario bus driver practice test questions are a valuable tool for those preparing for their bus licence exam, especially in the chapter “Bus Licence, Inspection and Road Check.”

Ontario Bus Driver - Chapter 1-2: Bus Licence, Inspetion and Road Check

1 / 30

Which of the following is included in the outside inspection list in addition to lights and exits?

Ticket printer

Radio antenna

Fuel system (tank, cap and check for leaks)

Destination sign

2 / 30

How do you correctly test the parking brake?

Drive at highway speed and then pull the brake

Turn off the engine and remove the key

Step on the service brake while the parking brake is off

Put the vehicle in gear with the parking brake on; it should hold the bus stationary at idle speed

3 / 30

Who must install wheels and tires on the vehicle?

The vehicle owner only

A passenger with experience

A certified tire installer or a mechanic

Any licensed driver

4 / 30

When can you perform a daily road check?

Only at a certified inspection station

Only when the vehicle is fully loaded

Only at the end of the workday

On the way to pick up the first passengers of the day

5 / 30

How is steering free play (lash) checked?

With engine on and wheels straight; turn the steering wheel with fingers until tire resistance is felt

By checking the steering fluid colour only

With engine off and wheels fully turned

By rocking the vehicle side to side

6 / 30

What is a proper shifting technique for standard transmissions to avoid clutch wear?

Hold the clutch pedal halfway down while driving

Shift as quickly as possible regardless of engine speed

Avoid changing gears on hills

Carefully control engine speed to shift without jerking or excessive clutch slippage

7 / 30

What class of licence is required to drive a bus with seats for 10–24 passengers (not including school‑purposes buses carrying passengers)?

Class C

Class D

Class G

Class F

8 / 30

A Class F licence allows the driver to operate vehicles in which other licence class in addition to F?

Class G

Class A

Class D

Class C

9 / 30

How should you test the brakes during a road check?

By coasting without using the brakes

At low speeds, bringing the vehicle to a complete stop in a straight line

By applying the brake only at high speeds

By stopping only in sharp turns

10 / 30

Which condition can result from broken springs, ruptured air bags, or faulty shock absorbers?

Quieter engine operation

Faster acceleration

Sag, bouncing, bottoming, and excessive sway when driving

Improved fuel economy

11 / 30

What must be checked regarding the steering system during the inside inspection?

Steering fluid colour

Steering wheel padding only

Steering wheel for excessive freeplay

Steering column paint condition

12 / 30

Which of the following is included in the inside inspection of the passenger and driver area?

Colour of seat upholstery

Passenger ticket stubs

Advertising posters

Passenger compartment condition, emergency equipment, and driver’s seatbelt and seat security

13 / 30

What is the most frequent cause of parking brake failure?

Not using the parking brake at all

Driving with the parking brake on

Using the service brake too often

Parking on flat surfaces only

14 / 30

What is meant by “free play” in a properly adjusted clutch pedal?

The pedal resting on the floor at all times

No movement at all when released

The pedal moves freely with no resistance throughout its travel

Some movement in the pedal when fully released

15 / 30

A Class C licence allows the driver to operate vehicles included in which licence classes?

Classes B, D and G

Classes D, F and G

Classes D and G only

Classes F and G only

16 / 30

What class of licence is required to drive a bus with seats for more than 24 passengers (not including school‑purposes buses carrying passengers)?

Class G

Class C

Class D

Class F

17 / 30

After installing new tires or wheels, when should wheel fasteners be rechecked?

Between 80 and 160 km after installation

They never need rechecking

After 500 km only

At the next annual inspection

18 / 30

How should a manual transmission operate when checked?

It should allow for smooth, easy gear changes

It should resist shifting to prevent wear

It should make loud noises to signal each gear

It should only shift when the engine is off

19 / 30

What air‑brake related check is required during the outside inspection?

Tank draining

Air brakes for audible air leaks and push rod travel

Air‑dryer replacement

Compressor overhaul

20 / 30

Why must tires and wheels be checked during the pre-trip inspection?

To ensure tread depth and wheel attachment meet safety standards

To make sure hubcaps are shiny

To verify the tire brand and model

To match tire colour on all wheels

21 / 30

What does excessive free play or lash in the steering system mean?

The steering wheel rotates too far before the tires begin turning

The power steering pump is too loud

The steering wheel is difficult to turn at all

The tires are overinflated

22 / 30

Who has the authority to perform a safety inspection on the vehicle at any time and location?

A towing company representative

A police officer or appointed ministry officer

Any passenger

Only the vehicle owner

23 / 30

Which of the following indicates a possible brake problem during testing?

Short stopping distance with no pull

Smooth, straight stops with normal pedal feel

Firm pedal and quiet operation

Pulling to one side, excessive noise, extra pedal pressure, or spongy pedal

24 / 30

When starting an engine with a standard transmission, what should the driver do with the clutch pedal?

Pump the clutch pedal rapidly

Depress the clutch pedal to relieve the starter of turning the transmission gears

Partially depress the clutch and accelerator together

Avoid touching the clutch pedal

25 / 30

What should drivers quickly recognize as a sign of a flat or under-inflated tire?

Strong steering response

Brighter dashboard lights

Increase in vehicle speed

A “thump-thumping” sensation while driving

26 / 30

How should the clutch engage in a properly functioning standard transmission?

After the pedal is fully released and the engine stalls

Easily and smoothly, without jerking, slipping excessively, or chattering

Only at very high engine speeds

With a strong jerk at the end of pedal travel

27 / 30

To operate a bus equipped with air brakes, what must be added to your driver’s licence?

X endorsement

Air endorsement

Bus endorsement

Z endorsement

28 / 30

During the daily road check while driving, what is the main purpose of planning a road check?

To evaluate steering, suspension, clutch, transmission, driveline, engine performance, and brake stopping power

To check the cleanliness of the vehicle interior

To test passenger comfort features

To improve fuel mileage only

29 / 30

Which braking‑related items are checked during the inside inspection?

Brake lining temperature

Brake pedal reserve and fade, brake booster operation, brake‑failure warning light

Parking brake cable lubrication only

Brake drum thickness only

30 / 30

What should you be alert for during an engine check?

The temperature of the steering wheel

Unusual engine noises, vibrations, or lack of normal responses

The brightness of the dashboard lights

The colour of the paint under the hood

Your score is

This chapter tests your understanding of licensing requirements, including necessary documents and qualifications. It also covers daily vehicle inspections—checking brakes, lights, tires, and emergency exits to ensure safety. Practice questions often include scenarios about responding to roadside inspections or presenting required paperwork to authorities. Using free practice test questions helps you become familiar with real exam formats and reinforces knowledge of safety checks and legal responsibilities. By practicing these questions, you build confidence and improve your chances of passing the Ontario bus driver test on your first attempt.