Chapter 2-2: Putting vehicle in motion

The “Putting Vehicle in Motion” section of the Ontario truck driver knowledge test focuses on the correct procedures for safely moving a commercial vehicle from a stop.

Ontario Truck Driver Test - Chapter 2-2: Putting vehicle in motion

1 / 3

When starting to move the vehicle, what should you do with the clutch?

Do not use the clutch at all

Gradually release the clutch

Press the clutch fully and hold it

Release the clutch suddenly

2 / 3

After the vehicle starts moving, what safety check must be done within at least 15 metres (50 ft.)?

Check the tire pressure

Check the fuel level

Check the engine oil level

Check the brakes

3 / 3

What should you do with the hand control valve or parking brake when putting the vehicle in motion?

Pump it on and off quickly

Apply it harder while releasing the clutch

Release it at the same time as you gradually release the clutch

Keep it fully applied until the vehicle reaches full speed

Your score is

This section evaluates a driver’s understanding of steps such as ensuring mirrors are properly adjusted, checking blind spots, signaling intentions, and gradually releasing the parking brake. Drivers are also tested on the importance of smoothly accelerating and maintaining safe control as the vehicle begins to move. Knowledge of these procedures is vital for preventing accidents and ensuring road safety. Mastering this section demonstrates readiness to operate a commercial vehicle responsibly on Ontario’s roads.