Series 5-34: Loading Using a Lift

The “Loading Using a Lift” section of the Alberta School Bus knowledge test focuses on the correct procedures for safely loading passengers who use wheelchairs or have mobility challenges.

Alberta School Bus Test - SERIES 5-34: Loading Using a Lift

1 / 10

Before raising the lift, what must the operator ensure about the passenger’s mobility aid brakes?

They remain applied during the entire lift operation

They are never used during loading

They are applied on the ground, then released before raising the lift

They are applied only after the lift is raised

2 / 10

How should the passenger be positioned on a side-loading lift?

It does not matter which way they face

Facing away from the vehicle

Sideways to the vehicle

Facing the vehicle

3 / 10

When preparing to use a vehicle lift, what is the FIRST safety step the operator should take?

Put up the safety plate on the lift

Check the passenger’s lap belt

Lower the lift to ground level

Apply the parking brake

4 / 10

What should the operator do with the lift and doors after the passenger is secured inside the vehicle?

Close only one door and leave the other open

Raise the lift but ignore the doors

Return the lift to the upright position and ensure the doors are closed before re-entering the vehicle

Leave the lift down in case it is needed again soon

5 / 10

What should the operator do if they become distracted while following the loading routine?

Ask the passenger to finish securing themselves

Return to their established routine to ensure no steps are missed

Skip to the final step to catch up

Restart the entire trip from the depot

6 / 10

What must be done with the safety plate on the lift before starting to raise the passenger?

Leave the safety plate down at all times

Ensure the safety plate is up (if it does not go up automatically)

Remove the safety plate to avoid tripping

Raise the safety plate only after the lift reaches floor level

7 / 10

What should the operator do while riding on the lift with the passenger, when possible?

Keep one hand on the mobility aid to detect any movement

Sit in a seat and let the lift operate automatically

Hold onto the vehicle door instead

Stand away from the mobility aid and watch from a distance

8 / 10

After rolling the mobility aid into the vehicle, what is an important step before moving the vehicle?

Apply the mobility aid’s brakes and use tie-downs, seat belts, and shoulder straps

Raise the lift but leave the doors open

Release all straps so the passenger can move freely

Immediately drive off to save time

9 / 10

How should unloading using a lift be carried out?

By reversing the procedures used for loading

By pushing the mobility aid down the steps instead

By letting the passenger operate the lift alone

By creating a new procedure each time

10 / 10

What is the correct action regarding the vehicle doors before operating the lift?

Partially close the doors to guide the lift

Make sure the doors are locked open and cannot swing closed

Close the doors to prevent drafts

Leave the doors wherever they happen to be

Your score is

Drivers are tested on their ability to operate the lift equipment, secure passengers and their devices, and ensure all safety protocols are followed. This section emphasizes the importance of patience, clear instructions, and attentiveness to each passenger’s needs. Proper use of the lift not only prevents injuries but also promotes dignity and independence for those requiring assistance. Mastery of these procedures is essential for providing accessible and inclusive school transportation.