Chapter 4-2: Traffic signs and lights

The free Ontario bus driver practice test for the “Traffic Signs and Lights” chapter is an excellent resource for aspiring bus drivers.

Ontario Bus Driver - Chapter 4-2: Traffic signs and lights

1 / 30

When are you allowed to turn left on a red light (unless a sign prohibits it)?

Only if there is a green arrow

When moving from a one-way road onto a one-way road, after a complete stop and when the way is clear

Whenever the intersection is empty

Anytime after slowing down

2 / 30

When are you allowed to turn right on a red light (unless a sign prohibits it)?

Only during daylight hours

Without stopping if no one is in the intersection

Only when directed by a police officer

After coming to a complete stop and waiting until the way is clear

3 / 30

May pedestrians cross on a flashing green light or a left-turn green arrow?

No, pedestrians may not cross on those signals

Only in school zones

Only if there is no traffic

Yes, pedestrians may always cross

4 / 30

What does a green traffic light allow you to do?

Go straight, turn left, or turn right after yielding to vehicles and pedestrians already in the intersection

Turn left only when an arrow appears

Proceed straight only, with no turns allowed

Proceed without yielding to anyone

5 / 30

A crosswalk is usually marked by:

Two parallel white lines painted across the road

Two parallel yellow lines painted across the road

A series of X symbols

A single broken white line across the road

6 / 30

At intersections with pedestrian pushbuttons, what must a pedestrian do to get a walk signal?

Step into the roadway to trigger the signal

Wait until the light cycles automatically

Use the pushbutton to bring on the walk signal

Wave at the traffic camera

7 / 30

At a red light, if there is no stop line, crosswalk, or sidewalk, where must you stop?

Directly under the signal

Before the previous block

At the edge of the intersection

After entering the intersection

8 / 30

At a red light, if there is no stop line or crosswalk but there is a sidewalk, where must you stop?

At the edge of the sidewalk

At the light pole

Anywhere before the light

In the intersection

9 / 30

Yellow lines on the road are used to:

Indicate parking zones

Separate traffic travelling in opposite directions

Separate traffic travelling in the same direction

Mark pedestrian crosswalks only

10 / 30

What does a flashing or steady orange hand symbol mean for pedestrians?

They have priority over turning vehicles

They may start to cross but must hurry

They must not begin to cross

They may cross only halfway

11 / 30

What does a flashing red beacon above an intersection or stop sign mean?

You must come to a complete stop and proceed only when it is safe

Proceed as if the light were green

Stop only if another vehicle is present

Slow down but do not stop

12 / 30

Continuity lines that are wider and closer together than regular broken lines mean:

A pedestrian crossing ahead

Special lane-use information, such as lane ending or exiting

A no-passing zone

A school zone

13 / 30

When turning left or right on a green light, what must you do?

Proceed quickly before pedestrians step onto the road

Stop and wait for a red light

Yield the right-of-way to pedestrians crossing the intersection

Ignore pedestrians if you have a green light

14 / 30

A white arrow painted on a lane means:

You may turn in any direction

The lane is for buses only

You may move only in the direction of the arrow

You must stop in that lane

15 / 30

What is the symbol for pedestrians to walk at an intersection with pedestrian signals?

A yellow triangle

A white walking symbol

A red hand

A green circle

16 / 30

At a red light, where must you stop if there is no stop line but there is a crosswalk?

At the crosswalk, marked or not

At the traffic light pole

In the middle of the intersection

After crossing the crosswalk

17 / 30

What is a key feature of intersection pedestrian signals?

They control traffic on side roads only

They are used only in school zones

They always stop traffic in all directions for the same length of time

They give pedestrians more time to cross than regular traffic lights

18 / 30

What does a flashing yellow beacon indicate?

You must stop and then proceed

The road is closed ahead

You must make a right turn only

You must drive with caution

19 / 30

What is a traffic beacon?

A light attached only to school buses

A set of three coloured lights for normal traffic control

A rotating light used only on emergency vehicles

A single flashing light hung over an intersection or placed over signs or on obstacles in the road

20 / 30

White lines on the road are used to:

Mark only crosswalks

Separate traffic travelling in opposite directions

Indicate where passing is never allowed

Separate traffic travelling in the same direction

21 / 30

A stop line is:

Two solid yellow lines in the centre of the road

A single yellow line down the middle of the road

A single white line painted across the road showing where you must stop

Two parallel white lines across the road

22 / 30

What is a key feature of bilingual signs?

They only show symbols with no words

They appear only on highways

They use only English in designated areas

Messages may appear in both English and French on the same sign or on consecutive signs

23 / 30

What should pedestrians do if they have already started crossing and the hand signal appears?

Turn back immediately

Run diagonally to the nearest corner

Continue crossing as quickly as possible to a safe area

Stop in the middle of the road

24 / 30

If there is no stop line at an intersection but there is a crosswalk, you must:

Stop at the crosswalk, marked or not

Not stop at all

Stop anywhere before the intersection

Stop in the middle of the intersection

25 / 30

Two solid lines painted on the pavement near fixed objects such as bridge piers or concrete islands are used to:

Guide traffic away from the fixed objects

Show where to stop for a train crossing

Mark parking spaces

Indicate a pedestrian-only zone

26 / 30

At intersections with traffic lights but no pedestrian signals, when may pedestrians cross?

Only when cars are stopped in all directions

When facing a red light

On a flashing green light

When facing a green light

27 / 30

If continuity lines appear on your left side, it generally means:

The lane you are in is ending or exiting

Your lane will continue unaffected

You are entering a school zone

You must stop immediately

28 / 30

What does a yellow (amber) traffic light mean?

The light is malfunctioning

The red light is about to appear; stop if you can safely, otherwise proceed with caution

You must turn right

Speed up to get through the intersection

29 / 30

A pedestrian crossing (crossover) is marked by:

Two yellow lines with arrows

A series of broken white lines

Two white double parallel lines across the road with an X in each lane approaching it

A single white line across the road

30 / 30

What does a red traffic light mean?

You must slow but not necessarily stop

You may go if no one else is around

You must bring your vehicle to a complete stop

You may turn left without stopping

Your score is

This section focuses on helping candidates recognize and interpret various road signs and traffic signals they will encounter on the road. By practicing with these questions, drivers improve their ability to respond correctly to regulatory, warning, and informational signs, as well as traffic light signals. Using free practice tests helps drivers prepare for the official exam, boosting both knowledge and confidence. Ultimately, mastering this chapter is essential for passing the test and ensuring road safety in Ontario.